248-624-7710 / dedoes.com
Alliance A7 Assembly Instruc�ons
P1615 RV.5 2022-05-20
Step 1 – Remove the chimney top shelf and vent covers from the top of the heater housing and set aside for later in the assembly.
Step 2 – Install the four hex head screws that are included with the heater housing into the highest non-heated units, which may
include the base. The top screws should install into the inner hole loca�ons and the bo�om screws should install into the outer hole
loca�ons.
Step 3 – Place the heater over the four screws and re-�ghten the screws to secure the heater housing to the machine.
Step 4 - A�ach the moun�ng plate with the remote thermostat to the lower heated unit by holding the moun�ng plate against the
back panel of the cabinet with the thermostat inserted into the large square cutout. Secure with the four 6mm nuts and bolts
provided.
Chimney top shelf
Vent Covers
Heater Housing
Lowest
Heated Unit
Inner Holes
Outer Holes
Highest
Non- Heated Units
Moun�ng Plate
with the
Remote Thermostat
