24
Positioning the Appliance
How to Drain Excess Water From Hoses
If th e sink is 100 0 higher from the floor, the excess water in hoses cannot be drained directly
into the sink. It will be necessary to drain excess water from hoses into a bowl or suitable
con tainer th at is held outside and lower than t he sink.
Water Outlet
Connect the wat er d rain hose . Th e drain hose must be correctl y fitt ed to av oid w ate r leaks.
Ensure that the water inl et ho se i s not kinked or squashed.
The following things should be checked before starting the dishwasher.
Syphon Connection
The distance between the drain connection and the bottom of the applianc e must not be longer than 1000mm.
The water drain hose should be fixed.
The content of this manual is very helpful to the users.
After installation, please make sure to keep this manual.
Extension Hose
If you need a drain hose extension, m ake sure to use a sim ilar drain ho se.
It m ust b e no longer than 4 m etres; otherwise the cleaning effect o f the dishwasher could be reduced.
1
The dishwasher is
and fixed properly
levelled
2
The inlet valve is open
3
To avoid any water leak, check if inlet valve is correctly screwed to the dishwasher
4
The wires are tightly connected
5
The power is switched on
6
The inlet and drain hoses are knotted
7
All packing materials and printings
have been removed from the dishwasher.
Position the appliance in the desired locat ion. The back should rest against the wall behind it, and the sides,
along the adjacent cabinets or walls. The dishwasher is equipped with water supply and drain hoses that can
be positioned either to the right or the left sides to facilitate proper installation.
Please close the hydran t after use
Pull The safety supply hoses completely out from storage compartment located at rear of dishwasher.
Turn water fully on before starting the dishwasher.
1
Tighter the screws of the safety supply hose to the faucet with thread 3/4inch.
2
3
The appliance must be connected to the water mains using new hose-sets.
The old hose-sets should not be reused.
Water pressure must be betw een 0,04 MPa and 1 MPa. If t he pressure is be low the minimum
con sult our S ervice D epa rtment f or a dvice.
