42
CHANGING THE GAS SUPPLY
Note
The default settings on your hob are
for natural gas.
The injectors required for adapting the hob
to a butane/propane supply can be found in
the same plastic pocket as this guide.
Tip
In France, this hob can also be
adapted to propane/butane-air gas. The
adaptation kit is supplied on request by your
After-Sales Service Department.
Each time you change the gas supply, you
must complete the following steps:
—
Adapt the gas connection
—
Change the injectors
—
Adjust the hob connections.
•
Adjust the gas connection
: refer to the
“Gas connection”
paragraph.
•
Change the injectors
proceeding as
follows:
—
Remove the pan supports, heads and
covers from all burners.
—
Using the tool provided, unscrew and
remove the injectors located under each
crucible
(Fig. 01).
—
Replace with the new gas injectors; refer to
the injector positioning markers and the gas
settings table at the end of this chapter. The
new injectors should be fitted as follows:
—
First, manually tighten as far as possible.
—
Then fully engage the key onto the injector.
—
Draw a line on the burner plate using a
pencil, as shown
(Fig. 02).
—
Turn the wrench clockwise until the line
appears on the opposite side of the key
(Fig. 03).
Note
Exceeding this limit may damage the
product.
-
Replace the burner heads, burner covers and
pan supports on the hob.
•
Tip
Each time you change the gas supply,
tick the box corresponding to the new gas
level on the label found in the plastic bag.
See “Gas connection”.
Fig. 02
Fig. 03
Line
Line
Wrench
Wrench
Fig. 01
Wrench
Injector
Crucible
EN
2
2 // INSTALLING YOUR APPLIANCE
