1. Access the menus by pressing the two keys on the right simultane
ously.
2. Select the User menu by pressing the or key until the icon
flashes.
3. Press
to access the User menu.
Note
The User menu is available only if the icon flashes.
4. Press the or key until the desired parameter is displayed.
The parameters available to the User are displayed.
5. Go back to the main display by pressing the
h
key.
5.1.3 Accessing the Hour Run Meters / Timer Program / Clock
sub-menus
Note
The name of the PCB is displayed. Check that it is actually the
PCB on which the setting must be made.
1. Access the menus by pressing the two keys on the right simultane
ously.
2. Select the menu by pressing the or key until the icon flash
es. Confirm the selection by pressing the
key.
Note
The Hour Run Meters / Timer Program / Clock sub-menus can be
accessed only if the icon flashes.
3. Select the menu by pressing the or key until the desired sub-
menu is displayed. Confirm the selection by pressing the
key.
4. Go back to the main display by pressing the
h
key.
5.2 Start-up
1. Switch on the outdoor unit and the indoor module simultaneously.
2. The heat pump begins its start-up cycle.
If the start-up cycle runs normally, an automatic venting cycle is initi
ated. Otherwise, an error message is displayed.
Fig.24 Accessing the User menu
MW-5000008-1
Fig.25 Displaying the parameters of the
User menu
MW-5000040-3
Fig.26 Accessing the Hour Run Meters /
Timer Program / Clock sub-menus
MW-5000044-2
Fig.27 Displaying the parameters of the
Hour Run Meters sub-menu
MW-5000045-2
5 Operation
30
MIV-4
7623755 - v02 - 03072015
