9
lines. Then turn the power switch on
the fryer to the “OFF” position.
e.
Open the fryer door and be sure that
the filter is in the proper position
under the fryer drain valve.
f.
To open the drain valve, pull the
handle out and allow all the oil in the
fryer to drain into the filter pan.
g.
Turn filter switch “ON” to begin
pumping clean oil into the fryer.
Allow the oil to flow for a few seconds
to wash out sediment on the bottom of
the cooking vessel before closing the
drain valve.
h.
Push on the drain valve handle to
close. It takes approximately 5 to 7
minutes for the filter to pump all the
oil back into the fryer.
i.
Turn filter switch on the fryer to the
“OFF” position after all the oil has
been pumped back into the fryer.
Allow the pump to run for 10 – 13
seconds after air bubbles appear in the
fryer vessel before shutting off to clear
shortening/oil from the return lines.
NOTE: AFTER FILTERING IT MAY
BE NECESSARY TO SCRAPE OFF ALL
OF THE DEBRIS ACCUMULATED ON
TOP OF THE FILTER PAPER AND
DISCARD.
CAUTION
OPERATING THE BURNERS WITHOUT
OIL IN THE FRYER VESSEL WILL
CAUSE DAMAGE TO THE FRYER AND
VOID THE WARRANTY.
WARNINGS!
DO NOT LEAVE A FILTER
MACHINE UNATTENDED DURING
OPERATION. THE ACTION OF THE
OIL MOVING THROUGH THE
LINES COULD CAUSE A FLEXIBLE
RETURN HOSE TO POP LOOSE
AND LEAK HOT OIL.
AVOID SERIOUS SPILLING OF HOT
OIL ONTO THE FLOOR. DRAIN
ONLY THE AMOUNT OF OIL
INDICATED ON THE FILTER PAN.
