DCSENG S LT Series, Manual

Page: 25 / 29

S-Cutter
25
C. Check the handling of the major operation part
⦁ Supply grease oil regularly on the side of rotation gearbox and main gearbox.
- Inside gears of rotation gearbox can wear out and must be replaced regularly.
⦁ Check and supply indicated(synthetic gasoline engine oil) in the upper surface of
cutting gearbox.
- Replace the indicated oil once every 750hours / every 3months regularly.
- The amount of oil is 40ml(
±
3%) and if it is too much or less, it may be shorten
the lifespan of machine.
- Inside gears of cutting gearbox can wear out and must be replaced regularly.
⦁ Check for unusual noise before use.
⦁
Check the machine for leakage before using it.
- Do not use grease. (Debris may be stuck and caused damage)
D. Work place and storing after work
⦁ Store after applying lubricant(WD-40) on the metal parts.
⦁ It is recommended that workplace would be indoor where it is not humid and has
no temperature difference between daytime and nighttime.
⦁ Keep in a dry place after the operation, to prevent access to the children and
outsiders.
⦁ Do not use a vinyl cloth during long-term storage and use a well-ventilated cloth.
E. Alarm transmission and fuse inspection
⦁
When alarming due to overload and electric shock during operation
- When the LED lamp at the front of the control panel is blinking, reset the
Emergency Stop S/W.
⦁ When the LED lamp at the front of the control panel is off or cutting tool is not
rotating.
- Replace the fuse(5 ∅ -20mm, 250V–8A) which is attached at the side of
electrical box.
F. When the product does not operate properly
⦁
It is very dangerous for consumers to find or repair the fault area so please
contact nearest A/S center or agencies.