PIPE(TUBE) CUTTER Of Best Technology
18
www.s-cutter.co.kr
5) Adjusting the tool by operating the equipment while it is on the pipe
- Switch for the operation of equipment should not be adjusted while attaching the
pipe, but adjust the switch while holding it in hand.
- After the placement of equipment on pipe, check whether insert tip is attaching the
surface of pipe by rotating the adjusting wheel gradually. It becomes a standard to
obtain the accurate processing depth since the depth value of insert tip attaching
the outside diameter of pipe initially is relative.
- Rotate the adjusting wheel and descend the insert tip to the desired depth based on
the moment that the insert tip and pipe are attaching(refer to explanation of No.5
for the adjusting method).
6) Working after checking the final processing value
[Bevel processing]
- When beveling the pipe, attach the guide rolls at the back and in front to the
surface of pipe and process the processing through the introduction of guide roll as
shown in the picture below.
- In case of bevel processing, force into the vertical angle direction(diagonal direction
of pipe) for the processing when forcing on the equipment while following the guide
of the guide rolls at the back and in front.
Back guide roll
Front guide roll
Summary of Contents for S-CM4_M
Page 30: ...S CM4_M S CM4_OD...