DCS BH1 series, Installation Manual/User Manual

Page: 14 / 84

12
INSTALLATION
CAVITY DIMENSIONS
BH1-48R BH1-36R
Inches (mm) Inches (mm)
A
Maximum height of enclosure shell
35 1/2 (902) 35 1/2 (902)
B
Depth of enclosure shell
22 3/4 (578) 22 3/4 (578)
C
Minimum depth for hood swing
3 3/4 (95) 3 3/4 (95)
D
Width of enclosure cavity
45 3/4 (1162) 34 1/2 (876)
E
Height of enclosure cavity
10 1/8 (257) 10 1/8 (257)
f
Depth to gas supply opening
18 1/2 (470) 18 1/2 (470)
G
Height of opening for access doors/drawers
20 (508) 20 (508)
H
Width of opening for access doors/drawers
46 (1168) 34 (864)
Standard layout for non-combustible enclosure:
NOTE: If using a backguard
apron or rear wall, locate
electrical service on the
right hand side for rotisserie
motor connection
48" Models = 116,2 cm/45 3/4 "
36" Models = 87,6 cm/34 1/2 "
9,5cm/3 3/4" min. for Lid
10,16 x 10,16cm
(4 x 4")
opening for gas
supply line
57,79 cm/22 3/4"
46.36 cm/
18 1/2 "
25,72 cm/
10 1/8"
64,5 cm
2
/10
"2
min
ventilation left
64,5 cm
2
/10
"2
min.
ventilation on
the back side
2,54 cm/1" min.
WARNING!
If installing the grill into
a non-combustible
enclosure, all combustible
construction must still be
outside the 18 inch
clearance zone. If your
island is made of stucco
over the top of wooden
studs, the wood can not
be inside the 18 inch
clearance zone to
combustible, even though
the stucco is what is
touching the grill area.
D
E
G
H
F
A
B
C
Built-in Construction Details
Standard layout for non-combustible cavity
IMPORTANT!
If installing the grill into a non-combustible enclosure, all combustible construction must still be
outside the 18" (457mm) clearance zone. If your island is made of stucco over the top of wooden
studs, the wood can not be inside the 18 inch clearance zone to combustible, even though the
stucco is what is touching the grill area.
Note: The enclosure should have
ventilation holes to prevent gas
build-up in the event of a leak.
Refer to ANSI Z21.58 Standard for
Outdoor Cooking Gas Appliances,
Section 1.7 Enclosures For Self
Contained LP-Gas Supply Systems.
Note: 4x4” (102 x 102mm)
opening for gas supply line.
FIG. 04
Note: the cut-out of
each corner should be a
90°angle in order for the
access doors/drawers to
fit properly.