DCB, Inc.
2949 CR 1000 E
Dewey, Illinois
61840
217.897.6600 Tel
800.432.2638 Toll Free
217.897.1331 Fax
www.dcbnet.com
G -> Upgrade Firmware
Select “B - > Backup Setup” Select “1+1 Port Backup”. This selection pairs ports 1 & 5, 2 & 6,
3 & 7, 4 & 8. They are digitally bridged together.
SLOT 3 8DBRA P1 === Backup Setup === 12:01:19 12/01/2010
ARROW KEYS: CURSOR MOVE, TAB: ROLL OPTIONS
Backup Type : 1+1 Port Backup
Warning!! Change Backup Type will clear map.
Next you can select “S - > RS232 Config Setup”. This is reference only. The card supports any
async speed up to 19200 bps regardless of what is on this screen.
SLOT 3 8DBRA P1 === RS232 Setup === 12:04:25 12/01/2010
ARROW KEYS: CURSOR MOVE, TAB: ROLL OPTIONS
RATE : 9.6KBps
Interface : 8RJ
Back out to the Port Menu and select “K - > Port Map Setup” See the port map setup on the
next page. You will need to map only ports 1, 2, 3 and 4.
In the example below, RS232 (the physical port) is mapped to time slots 1, 2 and 3 of Virtual Port
1. This will allow the data from RS232 port 1 to be mapped to 3 different DS-0s. Use the arrow
keys to move down the screen from Virtual Port, to TS start, to Total TS, RS232 Port and
Command. When you get down to “Command : Set”, use the “Enter” key to accept the
selection. Using the arrow key does not accept the mapping.
Page 5
