2021/06/21
80458 PAGE 5/9
STOCK
STOCK
#2. CYLINDER
STOCK
#23. GASKET, 12MM RUBBER
#18. GASKET, CYLINDER
#24. PIN, DOWEL 8X12 (2)
#5. RING SET, PISTON
#4. PISTON
#6. PIN, PISTON
#31. BOLT, STUD M6X26
#7. CIRCLIP (2)
10N-m
5~8N-m
#31. BOLT, STUD M6X26
TOP RING
SPACER RING
RAIL
“ ” Mark indicating
the exhaust side
“N” MARKING
STOCK
Do not tighten in this procedure
2. PISTON / CYLINDER
Assemble the piston rings to the piston.
Assemble the piston to the connecting rod.
(Pay attention to the direction.)
Install the dowel pin (8x12mm) into the crankcase.
Set the cylinder gasket and 12mm rubber gasket.
Install the stud bolt to the cylinder.
Be careful not to tighten too tightly.
Do not over tighten or the flatness of the cylinder will be compromised.
If the flatness is compromised, oil leakage may occur.
Apply a generous amount of oil to the cylinder.
Assemble the cylinder,
and then assemble the guide roller (stock).
Caution
！
OIL
OIL
OIL
OIL
OIL
