![background image](http://html1.mh-extra.com/html/daytona/c896cmll/c896cmll_user-manual_3929960014.webp)
13
4.2.4
Tire disassemble
◇
As shown in Picture 12, adjust the position to press Hook Head to wheels. Turn the twist on the right
Hand Control Valve and press the Hook Head into tires opposite the gaps between bead and rim.
◇
Turn the lower twist down to force a gap between the bead and the rim. Hook head is parallel to the rim
and 2mm against the rim. Then make it 2mm higher than rim. Insert the plastic crowbar between rim
and the top bead of the tire as shown in Picture 12-B(Protect Rims and Wheels). (Note: To run-flat tires,
the control twist(Z) must be turned backward and drive out the air in cylinder, or the Hood head may
rebound to scratch the wheels or even tear the bead. Please be especially careful to avoid the Hook Head
from touching the tire pressure monitoring device when demount tires with tire pressure monitoring
device.) Generally when Center Spindle turns a half circle the up bead can leave the wheel. Practice
more, it will never scratch or do other damage to wheels, rims or tires.
◇
As shown in Picture 12-D, pull the controller, make the Hook side down
。
◇
As shown in Picture 12-D
,
move the Hook Head
(
Z
)
against bottom rim about 3mm-5mm. Turn
up the twist(Z) with right hand and hold the lower bead of tire with left hand. The position of Hook
Head is as Picture12-E. Step motor pedal(V1), totally separate tires and wheels. (
Notice:
Hook Head
should be strictly fixed as the position shown in Picture12-E. Finishing disassembling tires, please turn
the Straight Side down and prepare mount tires. )
Notice
:
When demounting or mounting tires
,
Spindle should always turn clockwise
;
If Spindle
turn counterclockwise, it means the machine gets malfunction or the operator makes fault
.
Picture 12
Picture 12-A
12B
12C
Summary of Contents for C896CMLL
Page 20: ...7 0 Explosive View ...