4096-225
3.4M & 3.7M Az/El TRUSS MOUNT
31
3.
If the reflector does not check out as described above within approximately a
1/4", reflector adjustment may be done. Identify the point on the rim that is either
high or low. Loosen the four bolts on the long and short angle brace behind the
radial line of the reflector. Gently push or pull on the reflector rim until it is
brought into position. While one installer holds the rim, the other should tighten
all the brace bolts fully. Repeat this process as required, loosening and tightening
only one set of braces at a time.
ELEVATION
Inclinometer
FIGURE 12
