daviteq iConnector STHC, User Manual

Page: 6 / 30

0x2300-
0x24FF
512 RAM R The intrinsic data of iConnector
0x3000-
0x30FF
256 RAM R/W
0x5000-
0x50FF
256 FLASH R/W
0x6000-
0x6FFF
4096 RAM R Save data read from modbus slaves
Data address area: 0x2000-0x22FF (768 bytes), and 0x6000-0x6FFF (4096 bytes).
Controller address area: 0x3000-0x30FF (256 bytes, without flash storage), and 0x5000-0x50FF (256 bytes,
with flash storage).
256 bytes;
Save in flash (when power is lost, will keep the same value);
Allows reading, and writing from Globiots;
Allow log (realtime);
Allows Modbus write to Slaves;
It is not allowed to store data read from Modbus Slaves.
Up to 20 different log cycles;
320 log parameters maximum for all log cycles.
Up to 120 log parameters per log cycle.
Support modbus RTU.
Address slave 1… 247.
It is not allowed to set address slave = 0.
Baudrate 4800/9600/19200.
Parity none / odd / even.
Up to 100 modbus instructions.
The address area for storing read data: 0x2000-0x22FF (768 bytes), and 0x6000-0x6FFF (4096 bytes).
Controller address area: 0x3000-0x30FF (256 bytes, without flash storage), and 0x5000-0x50FF (256 bytes, with
flash storage).
Read up to 200 parameters.
If all parameters are float (4 bytes) then read up to 140 parameters.
The fastest realtime sending frequency is 1 second.
Up to 28 alarms.
Supported data types:
Address area 0x5000-0x50FF
NOTE:
Flash recorded about 100,000 times will be damaged so do not use this area to contain the value is changed
several times.
2.1.3 Logged data
2.1.4 Modbus
2.1.5 Realtime
2.1.6 Alarm