daviteq iConnector STHC, User Manual

Page: 14 / 30

To configure the iConnector, there is a Software run on Windows OS (Window 10 is recommended);
Please download the software at link below:
https://filerun.daviteq.com/wl/?
id=lNjzZbDo7Jwyr1x8DAD3x620tNK5u8lF
Unzip the file, it will extract 04 files as below picture:
Double-click the application file, named: iconnector_config to run the application. You will see the application
as below.
In case your computer has not got the driver, please follow these step to install the driver for Window 10:
https://ftdichip.com/wp-content/uploads/2020/08/AN_396-FTDI-Drivers-Installation-Guide-for-Windows-10.pdf
3.1.2 Offline Configuration Software:
Any desktop or laptop computer with USB-A port and Windows 10 OS can be used with this Software
There should be the COM port when you plug in the USB plug of configuration tool. If there is no, please:
* Install the COM Port driver as below instruction 3.1.3;
* After that close and open the software again.
3.1.3 Install the Driver for COM Port:
After install the driver successfully, please close and open the software again.