CAP10G is intended to use with Diesel Oil, Vegetable Oil.
CAP10G must not be used with other flammable fluid such as Gasoline, Alcohol, Ethanol, Acetone, Toluene or
other solvents.
Be careful while drilling, cutting, grinding, etc. The fuel tank or other flammable fluid.
Daviteq is not responsible for compensation in case of explosion to bodily injury or property damage.
Read specifications thoroughly and make sure that its output are suitable to reading devices.
Power supply must be in the permitted range.
Do not take out the label and take off the lid as this will lead to the instability of the sensor and manufacturer
could deny warranty. (except cutting of sensor length within the allowed range).
Make sure all the necessary tools are ready before the installation.
CAP10G be equipped with screws. We advise customers should use stainless steel rivets to fasten
the plastic flange onto tank for all type of tanks and only using screws for the thick and hard ones.
Sensor length
Standard 700mm, 1000mm, optional 1200 or 1500mm. Cuttable down to 200mm.
Longer than 1500mm, suggest to use Industrial type sensor CAP10CN
Output
240..33 ohms
Power supply
8..50VDC
Consumption
max 20mA
Working pressure
-1 .. 2 barg
Working temperature
-40 oC .. + 85 oC
Accuracy
+/- 0.5% of span (at 25 oC)
Temperature drift
< + 0.03% of span per 10oC
Resolution
1/1000 of span
Sensor materials
Alloy & Engineering plastic
Electrical connection
3-way connector IP67 from MOLEX with 3m shielded cable as standard
Housing
Cast alumium, IP67 protection
Process connection
Plastic flange
Standard accessories
flange, o-ring, gasket, protection covers, self-tapping screws, twisted seal, fuse & fuse
holder
Certification
CE-Marking per EN61236-1 (with test report)
4. Note Before Installation
5. Specification
6. Full Package
