![background image](http://html1.mh-extra.com/html/davis/and-vantage-pro/and-vantage-pro_reference-manual_3843210007.webp)
Page 7 of 52
"STRMOFF"
Stops sending sensor packets.
"VER"
Sends the firmware date code as a text string.
"RECEIVERS"
Sends the bit map of station IDs that the console can hear, This is not the byte for indicating what the
console selects to listen from.
"NVER"
Sends the firmware version number as a text string. This command is only supported by Vantage Pro2.
2.
Current Data commands
"LOOP <number of LOOP packets to send-decimal>"
Sends the specified number of LOOP packets, 1 every 2 seconds. Console sleeps between packets.
"HILOWS"
Sends all the current high/low data in a single 436 byte data block, plus 2 CRC bytes.
"PUTRAIN <Yearly Rain in rain clicks-decimal>"
Set the Yearly rainfall amount on the Vantage Console.
"PUTET <Yearly ET in 100th inch-decimal"
Set the Yearly ET amount on the Vantage Console.
3.
Download Commands
"DMP"
Downloads the entire archive memory.
See the sections IX.5 and IX.3 for more details.
"DMPAFT"
Downloads the records after a specified date and time. See the sections IX.5 and IX.3 for more details.
4.
EEPROM Commands
"GETEE"
Reads the full 4K EEPROM in one data block.
"EEWR <EE address-hex> <EE data-hex>"
Writes one byte of data to the specified address in the EEPROM.
"EERD <EE address-hex> <number of bytes to read-hex>"
Reads the specified number of bytes starting at the specified address. Results are given as hex strings, one
byte per line.
"EEBWR <EE address-hex> <number of bytes to write-hex>"
Writes data to the EEPROM. The data and CRC are given in binary format following an ACK response.
"EEBRD <EE address-hex> <number of bytes to read-hex>"
Reads data from the EEPROM. The data and CRC are given in binary format following an ACK response.
5.
Calibration Commands
"CALED"
Sends a block of data with the current temperature and humidity values for setting calibration values.
"CALFIX"
Updates the display when calibration numbers have been changed.
"BAR=<bar value to display (in Hg * 1000)-decimal> <elevation (ft)-decimal>"
Sets the elevation and barometer offset values when setting the barometer for a new location.