DaVinci 72” SS Timber Fire Log Set
Installation Instructions
Page 1 of 24
17602248 — 7/25/22
© Travis Industries, Inc.
Compatibility
72” DaVinci Timber Fire (Single Sided)
Overview
This kit includes all the logs and media needed for installation into the
72”- single sided
DaVinci Timber Fire
Fireplace. The log set has duplicates of some logs, but their positioning disguises the fact that they are the same.
Pay close attention to the log placement to ensure that the logs do not obstruct any of the burner holes.
Installation Warnings
NOTE
: The fireplace should be in place and vented and the firebacks must be installed prior to installing the log set.
WARNING
The logs are fragile, especially after being exposed to heat.
Make sure the gas control valve is OFF and the heater is cool prior to conducting service.
Failure to position the parts in accordance with these diagrams or failure to use only parts specifically
approved with this appliance may result in property damage or personal injury.
The burner must be correctly positioned before installing the log set. Make sure the burner is fully seated and
the pilot is properly aligned. See owner’s manual for details on burner removal.
72” Timber Fire Log Installation Overview
This log set is used in the single sided 72” version of the Timber Fire. There are multiple of some logs in the set.
Some face the service side of the fireplace and the other of the same log will face the back wall of the firebox so
only the back portion of the log is visible.
NOTE:
Make sure that the firebacks are installed before installing the log set.
Log
#1
Log
#2
Log
#3
Log
#4
Log
#5
Log
#6
Log
#8
Log
#7
Log
#8
Log
#10
Log
#9
DRAFT
DRAFT
DRAFT