1300 790 890
www.davidgolf.com.au
20
Electronic Mechanism Coin Programming
Xeptors
COIN LEARN PROCEDURE
1.
Slide the front cover up and identify the three controls to be used in this procedure:
a.)
The “test” push button near center bottom. (used to input the number
of credit pulses)
b.)
16 position rotary switch to the right of the push-button. (#0 is normal RUN
position, #1-#6 are for learning each of 6 possible coin types that can be accepted)
c.)
LED indicator half way up on the right side.
(Green in RUN mode, red in LEARN mode)
2.
Turn the rotary switch to one of the LEARN positions #1-#6 (for example, pick #3 for learning the
3rd coin type) and observe the LED turns red to indicate it is now ready to learn.
3.
Push the test button once for each credit pulse you wish to have issued for this coin.
4.
Slide the cover back on the unit to make sure outside light is does not interfere with the sensors.
5.
Show the unit 6 samples of the coin by depositing them into the acceptor as usual. It is best to use 6
different coins since there are typically slight variations from coin-to-coin.
6.
After the 6th sample coin is deposited, the LED will flash red-green a few times to indicate the
LEARN procedure is complete and the coin parameters are stored in memory.
7.
Slide the front cover open again and turn the rotary switch back to position #0 and observe the LED
turning green. Check that you have not accidentally turned it too far to position #15 which is a field
test function position, in which it will not accept coins.
8.
Slide the front cover back down and you should now be able to accept the new coin.
COIN UN-LEARN PROCEDURE
1.
Slide the front cover up and turn the rotary switch to the coin # position you wish to UN-LEARN.
2.
Push the test button once to initiate the LEARN sequence.
3.
Turn the rotary switch back to position #0 without depositing any coins to signal the unit that you
wish it to erase the parameters for this coin. The LED will flash red-green to indicate completion.
4.
Slide the front cover back down.
Summary of Contents for Easy Picker BALL DISPENSER
Page 15: ...1300 790 890 www davidgolf com au 15 FIGURE 10 WIRING 120 VAC TO 12 VDC 2010 TO PRESENT ...
Page 16: ...1300 790 890 www davidgolf com au 16 FIGURE 11 WIRING HARNESS 2010 TO PRESENT ...
Page 22: ...1300 790 890 www davidgolf com au 22 ...
