1300 790 890
www.davidgolf.com.au
17
Troubleshooting
Any evidence of malfunction, however minor in character, should be investi-gated and corrected be-
fore it develops into a major fault which may disable the Ball Dispenser for lengthy and costly repairs.
Troubles most likely to be encountered, their probable cause and remedy are listed in the following
Table:
WARNING
ENSURE ELECTRICAL POWER HAS BEEN DISCONNECTED BEFORE PERFORMING ANY
REPAIR OR CONTINUITY CHECKS TO AVOID PERSONNEL INJURY. USE CARE WHEN
PERFORMING VOLTAGE MEASUREMENTS TO AVOID PHYSICAL CONTACT WITH
PARTS OR SURROUNDING CIRCUITS.
TROUBLE SHOOTING GUIDE
PROBLEM
Token slide will not engage.
Correct token goes to coin
return instead of coin box.
(electronic mechanism
Only).
Range balls will not dispense.
PROBABLE CAUSE
Jammed token or coin.
Token Slide Mechanism
defective.
Facility power not turned on.
Electronic mechanism
not programmed.
No power to ball dispenser.
GFI tripped.
REMEDY
Remove.
Replace.
Connect facility power
See electronic programming
Page 27.
Turn power on and check for a
green LED at GFI
Depress GFI reset button LED
on GFI
On top right corner.
If GFI will not reset, inspect
wiring for possible shorting or
electrical component failure.
Replace wiring or component.
Summary of Contents for Easy Picker BALL DISPENSER
Page 15: ...1300 790 890 www davidgolf com au 15 FIGURE 10 WIRING 120 VAC TO 12 VDC 2010 TO PRESENT ...
Page 16: ...1300 790 890 www davidgolf com au 16 FIGURE 11 WIRING HARNESS 2010 TO PRESENT ...
Page 22: ...1300 790 890 www davidgolf com au 22 ...
