17
Priming Speed / Max Speed
Each time your pump starts it will go through 2 minutes of priming to ensure
there is water in the system. You can adjust the speed in which it does this
between 5 & 10. The speed you set will limit the maximum speed the pump
will run in manual or schedule mode.
Backwash
Can be set as a single speed or alternatively set two speeds and the pump
speed will “pulse” between the two settings. Minimum speed can be set
between 1-10, maximum speed can only be set between 5-10.
• “External Timer Present”
- Swipe this on or off, depending on whether you are using an external
timer/chlorinator.
• Disconnect Function
- The “disconnect from pump” function can be used to:
- 1. Allow another device to control the pump
- 2. Disconnect so that you will not automatically connect to the pump.
- Please note that the Bluetooth connection will automatically disconnect
after a minute of no communication
• “Factory Reset”
- This will reset the pump back to factory configurations and allows you to
start the setup process again.
- Select “reset pump”
- Turn dial to “off” position, then turn dial to “Bluetooth”
- You can then repair with your phone. This procedure is in place so that the pump
cannot accidentally be reset.
