5
Installation of the ProMaster
TM
VSD Eco-Series Pump:
Location
The pump should be located as close to the water as practicable and mounted
on a firm base in a well drained position, high enough to prevent any flooding. It is
the installer’s/owner’s responsibility to locate the pump such that the nameplate
can be easily read and the pump can be readily accessed for service.
Weather Protection
It is recommended that the pump is protected from the weather. Enclosures
should be ventilated to prevent condensation build-up.
Power Connection
Davey ProMaster
TM
is suitable for connection to a nominal 220/240 volt 50/60Hz
power supply and are equipped with a flex and 3 pin plug. If a power outlet is not
available within 3 metres of the pump, a 3 pin power point in a safe, dry place
may need to be provided by an electrician. Extension cords are unsafe around
pools - and should be avoided. If the supply cord of this product is damaged it
must be replaced by the dealer or manufacturer, with genuine Davey spares.
This ProMaster
TM
pool pump incorporates motor overload detection designed to
protect the motor from overheating. If the motor gets too hot during operation, it’s
operating speed will reduce to bring it within a acceptable operating temperature
and then will speed up to the originally set speed.
To reset the motor, switch the power off for 30 seconds, and then return the
power from the mains switch.
