M 11
R
L
14
12d
12e
12
12
13
12a
17a
17
17
16
17
16
4. Mounting Instructions / installing the Saddle
Required part:
Required tool:
1 x Wrench
( 14 mm )
Install the saddle (13) on the dowel pin of
the saddle carriage on the saddle holder (12)
and set the saddle inclination by tilting it.
Tighten both of the nuts under the saddle.
Bring the saddle to the required horizontal position with
the sliding rail (12e) and fasten it with the button (12d).
5. Pedals Mounting Instructions
Required parts:
2 x pedals
Required tool:
2 x pedal staps
wrench 15 mm
Be careful to adjust the straps in such a way as to leave a sufficient loop to provide a
firm and comfortable foot support.
4.
1
4.
2
4.
3
4.
4
5.
1
5.
2
The pedal straps
are marked above the oblique perforations:
With an
for the left pedal, and with an
for the right one.
Pull the strap onto the lugs at the left and right ends of the pedal.
Put the strap end with two holes to the pedal's side closest to the device.
(16a/17a)
L
(17a)
R
(16a)
Screw the pedal marked with an
“L”
to the pedal rod on the left side, and the one marked
with an
“R”
to the pedal rod on the ride side of the bike when facing forward.
To avoid damaging the thread, you should start
screwing the pedals in place by hand, and
then tighten them very firmly using the wrench (15 mm).
Warning! Damage to the thread of the pedal rods
is not covered by the warranty!
The threads of the pedal rods are compatible with those of standard bikes. Consequently, you can
install any pedal of the commercially available various pedal types as needed.
Warning !!
The left pedal (17) has a left-hand thread, and must therefore be screwed
in place by turning it counterclockwise.
The right pedal (16) has a right-hand thread and must therefore be screwed
in place by turning it clockwise.
Die Pedale und die Pedalarm-Befestigungsschrauben
( unter der Pedalarm-Kunststoffkappe )
müssen
nach ca. 100 km Fahrstrecke, danach alle 500 km Fahrstrecke, unbedingt nachgezogen werden !
clockwise
counterclockwise
Turn pedal
Mounting The Saddle And Pedals
right
left
Pedal rods
Pedal rod attaching screw
and pedal rod plastic cap
1 x Saddle
Install the saddle holder (12) in the frame
and fasten it by mean of the toggle button (12a)
Assembly
Description
Summary of Contents for Cardio 2002 PC
Page 1: ......
