PSM-500/500L/500LT SCPC Satellite Modem
Operation
PSM-500/500L/500LT - Rev. 0.91
Page 3-11
LNB column is only available on Land LT models.
Sweep Time is only visible if Sweep Mode is set to “Search”.
Buffer Parameters are only visible if the Data Clock Source is not set to “Demod”, enabling the
buffer.
Dif Decoder is disabled and not visible with Turbo Product Codes Option installed and enabled.
Table 3-4
PSM-500 Front Panel Parameter Matrix – Interface Sheet
Status
I/O
SnIP or SDMS
Alarm
Test
I/O
Mode
IP Addr
Tst Active
Ter Loopbck
RTS
Format
Netwrk Mask
BER Loss
Sat Loopbck
CTS
RTS
MAC Addr
SnIP or SDMS BER I/O
DCD
CTS
Options
Mod BER
DTR
DCD
Version
Demod BER
DSR
DTR
Serial#
Test
DSR
Test BER
Xmt Data
Sync Loss
Xmt Clock
Errors
Rcv Data
Bits
Rcv Clock
EFS
RTS Monitor
Erred Sec
Total Sec
Note: The seven shaded BERT Status column items are only visible when the Demod BER is
enabled in the Test column.
The center column is used for interface option expansion, and is only displayed with an option
installed. The entries shown are only representative of one type of option interface.
The RTS Monitor function is only available in firmware versions 0.47 and after.