USER
’
S MANUAL
12
Chapter 3 SAFETY
Safety tooth and gear module are parts which guarantee the safety of personnel beneath the machine in
failure condition of other protections. So make sure the integrity of gear module and that the safety tooth
has occluded completely. (Picture 10)
There is nothing abnormal should be left on the safety modules to prevent safety gear from occlude
normally.
RISKS FOR PERSONNEL
This heading illustrates potential risks for the operator, maintenance fitter, or any other person
present in the area around the lift, result from incorrect use of the lift.
RISKS FOR EXTRUSION
During up and down operations, personnel leave the said area without following the rule and
instruction.
During up and down operations, no person is admitted to work beneath the movable parts of the
lift, should work in the safe zone. (Picture 6)
RISK OF IMPACT
Before the operator begins up and down movements, make sure that there are no personnel inside
the danger zone. When, due to operational reasons, the lift is stopped at relatively low elevations
(lower than 1.75m above the ground) personnel must be careful to avoid impact with parts of the machine
not marked with special colors. (Picture11)
RISK OF FALLING OFF (PERSONNEL)
During up and down operations, personnel are prohibited from entering the platforms and the
vehicle to avoid falling off.
Picture 9
Picture 10
Picture 11
(
risk of impact
)
Picture 12
(
risk of slipping
)
Summary of Contents for LJS6035
