USER
’
S MANUAL
18
Picture 22
-Use light hammer to install the ground bolts into the hole (do not need to install the
central expanded nail of ground bolts, and install it after level adjustment.)
Level adjustment
:
-
By using a level bar and the horizontal pipe and adjusting the adjustment screws at two sides
of the base plate.
-If platform unevenness is resulted from basic unevenness, use iron block to fill up the low
place.
-After level adjustment, insert the central expanded nail of ground bolts and use heavy
hammer to hammer it.
-Screw down the ground bolts cap.
When the expiry date on the maintenance of concrete hasn’t arrived, one c
an not install the
central expanded nail of ground bolts.
The gap between the base plate and ground after adjustment must be filled with iron plate or
concrete
.
No load of main machine test:
-Turn on the power QS.
-
Press “UP” button, pay attention to the s
ynchronization and placidity of the lifting.
-Check whether safety pawl is correctly located.
-Check whether the oil line and the air line are leakage.
Chapter 5 ADJUSTMENT
When testing the lift, no person or other things are allowed to stand or be put near
the two sides and beneath the machine. If any abnormal is found, press button
“
emergency stop
” to stop it timely. After clearing obstacles, do the test again.
Load of machine test:
-
Drive the vehicle whose weight doesn’t exceed maximum lift weight t
o the platform, and
then the driver leave it.
Picture 23
(
level adjustment
)
Summary of Contents for LJS6035
