Datcon DT9100 I4, Operating Instructions Manual

Page: 50 / 64

DT9100 I4

Use supervisor
Code
Synchronisation time set ( S ynchron T ime)
Here you can preset the synchronisation time for the remote
synchron function.
(The seconds are set to zero automatically.)

Use supervisor
code
Synchrinisation puls width set ( S ynchron Gate Time S et)
Here you can set the pulse width of the remote
synchronisation signal. When the active state of the
synchron puls is lower then this value the instrument doesn’t
accept it as a synchronisation puls.
E.g. when

is selected than the the loop current have
to keep over 12 mA for more than 2 seconds to stop the
clock and activate the synchronisation after the loop current
goes under 8 mA.

Use supervisor
code
1. digital output mode ( O utput 1 )
Here you can set Out1 (terminal 1, 2) digital output mode.
Yuo can use it for synchrinising other clocks selecting the
repeater function.

Use supervisor
code
2. digital output mode ( O utput 2)
Here you can set Out1 (terminal 3, 4) digital output mode.
Yuo can use it for synchrinising other clocks selecting the
repeater function.
50
20180905-V120180905-V1