Datcon DT9100 I4, Operating Instructions Manual

Page: 23 / 64

DT9100 I4
Finishing steps 1. Check if the cables are connected properly (have you
connected all the cables, have you connected them to the
right place, are not the cable ends touching each other).
2. Pull back the unnecessary cable length from inside of
instrument enclosure.
3. Tight the gland nut that the cable can not be moved by
pulling.
Operating check If the connections are appropriate, the display shows
numbers or text.
If the display shows nothing (no LCD segment lit), probable
the connections of wire not appropriate or the current do
not flow in current loop.
Check the connections and measure the voltage between
connectors 5 and 6, it must be about 2 VDC.
Assemble 4. Mount back the front cover as shown the chapter 4.3
Mounting back the front cover .
The mounting and connecting are finished.
20180905-V1
23