Datcon DT9100 I4, Operating Instructions Manual

Page: 21 / 64

DT9100 I4
5.3. Connecting into the current loop (synchronising
input)
Connecting as end
device The DT9100 I4 acts as a terminal device of the current loop.
In this case the signal comes via a pair of wires, and it does
not have to go to other devices.
The following figure shows the connection:
Wiring plan, connecting
into the current loop
(synchrinising input)
(see also “Application
example”)
Be careful the polarity of
the cables
1. Push the cable-end until it possible into the terminal
assembly. By pushing the wire in, the self-closing
connection is being established.
2. Check it by pulling it outwards slightly.
20180905-V1
21