DT1361
16
20171206-V0
6.2. Connecting the detector or the contact to the input.
The following figure shows the wiring plan, connecting the
detector or the contact to the input:
Wiring plan, connecting
the detectors or the
contacts to the inputs
(see also “Application
example”)
Be careful the polarity of
the cables
Checking the
connections
1. Loosen terminal screws.
2. Insert the wire ends into the open terminals according to
the wiring plan.
3. Screw the terminal in.
4. Check the hold of the wires in terminals by pulling on
them firmly.
Check if the cables are connected properly (have you
connected all the cables, have you connected to the right
place, do not the cable-ends touch each other).
Summary of Contents for DT1361
