Datcon DT1361, Operating Instructions Manual

Page: 17 / 36

DT1361
20171206-V0
17
6.3. Connecting the relay contacts and the power
supply
The following figure shows the wiring plan, connecting the
relay contacts and the power supply:
Wiring plan, connecting
the relay contacts and
the power supply
(see also “Application
example”)
Checking the
connections
1. Loosen terminal screws.
2. Insert the wire ends into the open terminals according to,
the wiring plan.
3. Screw the terminal in.
4. Check the hold of the wires in terminals by pulling on
them firmly.
Check if the cables are connected properly (have you
connected all the cables, have you connected to the right
place, do not the cable-ends touch each other).
The connection is finished.
6.4. Put the instrument under supply voltage
Put the instrument
under supply voltage
After you have completed the connections, put the
instrument under supply voltage. If the connection is correct
the green indicator gives light and you can detect output
state according to the detector state.