Datcon DT1361, Operating Instructions Manual

Page: 15 / 36

DT1361
20171206-V0
15
6. Connecting
6.1. Preparing the connection
Select and prepare
connection cable
Always observe the following safety instructions:
• When you are going to install instruments in hazardous
area or install instruments which are connecting to
instruments working in hazardous area you
should take
note of the appropriate regulations, conformity and type
approval certificates of the DT1361 and other connecting
instruments (e.g. detector). The connection must be carried
out by trained and authorized personnel only!
• Connect only in the complete absence of supply voltage
• Use only a screwdriver with appropriate head
Take note the suitability of the connecting cable
(wire cross-section, insulation, etc.).
The wire cross-section should be 0.25-1.5 mm
2 .
You may use either solid conductor or flexible conductor.
In case of using flexible conductor use crimped wire end.