Datavideo PTC-285W, Instruction Manual

Page: 18 / 132

18
No Function Keys Descriptions
1
Power Button
Power Button
Press this button once to enter Standby Mode, press it
again to enter Normal Mode.
Note: The power consumption in Standby Mode is
approximately half of the power consumption in Normal
Mode.
2
Camera 1-4
Camera 1-4
The camera 1 to Camera 4 buttons allow you to set your
PTC-285 cameras in No.1 to No. 4.

Please short-press the button 1 to button 4 to select
the camera 1, camera 2, camera 3 or camera 4.

Please long-press one of the camera 1 to camera 4
buttons. After that, those four buttons will be lit, at
this time, please short-press one of the four buttons
to finish the camera number setting.
PT
Preset1-4 Buttons
The Preset buttons 1, 2, 3, and 4 allow you to set up to 4
camera preset settings.
How to set the Preset: Please adjust your desired camera
parameters and camera lens position in advance. After
that, please press the “STR” button which is located on the
remoter controller. And then please press your desired
Preset Number button (Preset 1 to Preset 4) to set your
setting as a Preset.
How to recall the Preset: Please press the desired “Preset
No.” button (Preset 1 to Preset 4) directly and then the
presaved Preset settings will be recalled successfully.
Turn on the Auto-Tracking function: Please long-press the
“Preset 1” button for 2 seconds and then the Auto-Tracking
function will be turned on.
Turn-off the Auto-Tracking function: Please long-press the
“Preset 2” button for 2 seconds and then the Auto-Tracking
function will be turned off.