Adjustments and Maintenance
2-3
Step
Action
Displayed Message
Comment(s)
4
Ensure that no label stock is
installed in the printer then press
the ESC Key.
REMOVE LABEL STOCK
PRESS ESC KEY
yyy
This sets the empty value -
where ‘yyy’ is a numerical
value representing the sensor
reading when no media is
installed.
5
Proceed according to the kind of
media being calibrated:
Die-Cut Media -- Remove at least
six inches (15cm) of the
beginning label material from the
liner, and then install the media.
Adjust the Media Sensor (per the
table below) then press the ESC
Key.
Notched or Reflective Media --
Install media. Adjust the Media
Sensor (per the table below), and
then press the ESC Key.
Continuous Media -- Install
media. Position the Media
Sensor (per the table below).
For die-cut media:
SCAN BACKING
PRESS ESC KEY
yyy
- or, for reflective media:
SCAN MARK
PRESS ESC KEY
yyy
This sets the gap (or mark)
value - where ‘yyy’ is a
numerical value representing
the sensor reading for the
TOF indicator.
Do not position a media
perforation over the sensor
when taking any sensor
reading.
If using media with small
notches or reflective marks,
ensure that the labels exit
straight from the printer.
Do not move the position of
the Media Sensor following
this step.
Media
Sensor Type
Sensor ‘Red Dot’ Position
Die-cut
Gap
Centered under the label
Notched
Gap
Centered under the notch
Reflective
Reflective
Centered under the black mark
Continuous
Continuous
Centered under the label
