Datamax ANDES 3, User Manual

Page: 8 / 32

4
1.2.2 Charging the Battery

Plug battery charger adapter output cable into the battery charger connector as shown
in Figure 3.
FIGURE 3 – BATTERY CHARGER

Plug battery charger adapter into the appropriate AC line voltage socket.

The Yellow/Amber charging LED will illuminate indicating that the battery is being
charged

The battery will be fast charged and after about 180 minutes. The LED will turn off

To remove the battery cartridge, open the battery door and tip the battery out of the
printer
.
Note: To ensure a full charge do not operate the printer while charging.
Note: The wall mounted charger is a Class II equipment (
)
. Multiple plug configurations
comply with most international standards. The wall-mounted charger is not supplied with
plugs for use in Korea.
Model ANDES 3
Input Voltage/Current 100-240 VAC/0.4A
Input Frequency 47-63 Hz
Output Voltage/Current ( ) 10VDC/1.32A
Do not use a charger not approved by Datamax-O’Neil for use with the ANDES 3.
Use of an unapproved charger could damage the battery pack or the printer and will
void the warranty.
The battery terminals are well recessed inside the printer. Do not allow them to
contact conductive material since this may create a short circuit, which could
cause injury or start a fire.
When using the wall mounted charger, ensure the socket outlet is close to the
printer and easily accessible during the process. Switch the socket off, pull the
charger from the socket, or disconnect the plug from the printer in case of
problems.