Datamax ANDES 3, User Manual

Page: 10 / 32

6
1.4 Attaching Belt Loop System
The belt loop system consists of two parts as seen in Figure 5:

A knob located on the back part of the printer just above the battery door

A strap with click on connector
To attach the strap to the knob insert the knob located at the bottom of the printer into the
slot of the connector. Pull down until you hear a click. The printer is now secure. The loop is
then placed over your belt. Allow the printer to hang down to either the left or right hip.

To release the printer, press in on the two latches on the connector and pull the knob
clear of the slot.
Note: Do not force or pull the printer from the connector without pressing in on the two
latches
KNOB CONNECTION
FIGURE 5– KNOB CONNECTION AND QUICK CLIP