Datamax A-Class A-4310, Programmer'S Manual

Page: 98 / 302

Extended System-Level Command Functions
82 Class Series Programmer’s Manual
(RL) Ribbon Low Diameter –
This command sets the threshold for a low ribbon indication,
where nnnn is the diameter in hundredths of inches.
(RM) Rewinder Equipped –
This command allows the printer to sense the powered internal
rewind option. A or Y - automatically senses device presence; if undetected, no error is generated.
E - enables the device, where its presence must be detected; otherwise, a fault is generated. N or
D - disables device detection.
(RN) Reflective No Paper Minimum
– This command sets the media sensor’s reading for the Out
Of Stock (OOS) condition.
(RO) Row Offset
– See
Rnnnn
(in Label Formatting Command Functions) for command details .
(RP) Ribbon Low Pause
– This command (when enabled) pauses the printer when a Ribbon Low
Diameter warning is declared; the PAUSE Button must be pressed to continue printing.
(RR) Rewinder Adjust
– This command changes the torque applied by the powered rewinder, in
percentage points of the nominal force, to minimize TOF registration drift (sometimes evident
when using small or narrow media).
(RS) Ribbon Low Signal –
This command sets the signal output type for the Ribbon Low
Diameter condition when using the optional GPIO (see Appendix J).
(RV) Reflective Paper Value –
This command sets the threshold value for the reflective media
sensor’s paper parameter.
(RW) Retract Delay –
This command sets a time delay for the retraction of a presented label,
where the time specified is multiplied by ten milliseconds.