RHINO™
14
2
2.4 CONNECT SERIAL BARCODE SCANNER
Refer to the documentation received with the barcode scanner for complete instructions.
Read all warnings and caution labels.
Note
: Before using the scanner, read section titled “Operation”, sub-section titled “Laser
Barcode Scanner Warnings.”
Both COM1 and COM2/Scanner ports can be used to connect a barcode reader. Rhino™
has been designed to support 5V powered scanners through COM2/Scanner port (Pin 9 of
the connector). The maximum current sourced is 1 A.
The barcode input is managed by a specific driver: REDIR.exe, to be included in the
CONFIG.SYS system file.
REDIR.exe is configured for COM2/Scanner input by default.
Figure 19 - Connect Serial Scanner Cable to COM2/Scanner
1. Turn the RHINO™ off before attaching the serial cable.
2. Seat the connector firmly over the pins and turn the thumbscrews in a clockwise
direction. Do not overtighten.
3. Turn the RHINO™ on.
Figure 20 - RHINO™ with Tethered Generic Barcode Scanner
It is possible to select and configure the port for connection to a scanner/reader, via DL
Mobile Configurator™ included the Mobile@work Reference Disk).
COM1 and COM2 ports can be connected to any Datalogic reader with serial interface,
pinout permitting.
COM2/Scanner
