RHINO™
10
2
2 INSTALLATION
Rhino™ has been designed to guarantee a fast and easy during mechanical installation.
Rhino™ can be mounted either on the roof, on the floor or on a wall of a fork-lift, in addition,
it can be rotated in order to obtain the best display viewing.
Mounting material:
•
Rhino™
•
ST-222 Bracket (included in the package)
•
4 to 6 screws,
ø
= 8mm; since screw length depends on each situation, they cannot be
included in the package. It is recommended to use non-oxidable materials.
•
Nuts compatible with the screws of step no. 3
•
8 to 12 washers compatible with the above listed screws. Since screw length depends on
each situation, they cannot be included in the package
•
Power supply cable (included)
•
Two knobs (included)
•
Two plain washers and two notched washers
2.1 INSTALLATION ON FORKLIFT ROOF
Follow these instructions as indicative general guidelines:
1 Find the most suitable place on forklift roof to place Rhino™: it should be as much
protected as possible against water and dust, and it should not obstacle operator's
movements as well.
2 The slots on the bracket will help obtain the best positioning. When working in
environments characterized by strong vibrations, set the screws as next as possible to
bracket's edges.
3
Tighten the ST-222 bracket using the screws and washers. The clamping tooth at the
bottom of ST-222 should be at user's right hand side.
Figure 12 - Screw Positioning
4
Position Rhino™ at the bottom of the bracket: make sure the two large round openings
coincide to the ones located at the edges of Rhino™.
