Datalogic A30, Hardware Manual

Page: 12 / 64

A30™ HARDWARE GUIDE
2
1
STEP 2 – CONNECT THE SYSTEM
In the typical standalone layout shown in the figure below, an EtherNet host is connected to the
camera. The camera can use an external trigger to signal image acquisition.
The CBX is used to facilitate the connection between the camera and the host interface, external
trigger, and optional input and output devices.
A30™ Standalone Layout to Ethernet Host
• Power Supply Connection
Use the PG-120 power Kit (3 versions for European, UK or US plug) and CAB-PG-0002 +
BA400 connector to connect the PG-120 to the CBX. An alternative power supply to the PG-
120 is the PWR-120.
• CBX Connection
Use CAB-SCSxx between the A30 camera and the CBX for power, external trigger device
(photocell), and additional I/O connections.
Use the CAB-GE0x for the Gigabit Ethernet connection to the host.
NOTE
The A30 does not support sourcing power towards the CBX in order to
power I/O devices. These devices must be powered through the CBX or
from an external source.
CAB-GE0x
CAB-PG-0002
+ BA400
CAB-SCSxx
PG-120
Ext. Trigger
CBX500
I/O
Ethernet Host
(Data coll A30
configuration)
Camera