Datalogic A30, Hardware Manual

Page: 11 / 64

RAPID CONFIGURATION
1
1
1 RAPID CONFIGURATION
STEP 1 – ASSEMBLE THE CAMERA
The first step to perform is to assemble any accessories that make up the A30™ camera. A lens
must be used. A strobe or other external illuminator may be required.
CAUTION
The camera must be disconnected from the power supply during this
procedure.
1. In a dust-free environment, remove the Camera Lens Cover by unscrewing it.
CAUTION
Do not touch the sensor aperture, lens glass or lens cover glass. These
areas must be kept clean. Avoid any abrasive substances that might
damage these surfaces during cleaning.
2. Remove the sensor protection label (dust cap) by pulling it off of the base.
3. Mount a lens by slowly screwing it onto the base until it arrives at the mechanical stop.
Figure 1 – Assembling the Camera and Lens
4. To keep dust and dirt off of the lens during mounting, temporarily replace the lens cover.
Lens
Lens Cover
Lens Spacer
(optional)
Protective Film
(remove before calibration)
Camera