DataCard CR825, Installation And Administrator'S Manual

Page: 128 / 140

A-8 CE875 Instant Issuance System
Use the Bolt-Down Openings
The embosser includes bolt-down openings that you can use to secure the system to a mounting
surface.
1.
Open the embosser supplies access
door.
2.
If installed, remove the topping foil
and indent ribbon cartridges and set
them aside.
3.
Bolt the embosser to the work
surface.
You need the following supplies:

Two 1/4-inch (6 mm) bolts.
The length of the bolts depends
on the thickness of the mounting
surface. Bolt length minimum is
surface thi ¾ inch (20
mm). Bolt length maximum is surface thi1¼ inch (30 mm).

Two 5/8-inch (18 mm) outer diameter
washers.

Two 1/4-inch (6 mm) nuts. Lock nuts
are recommended.
a.
Drill holes in the mounting surface
following the dimensions and
requirements shown on the following
page.
b.
Insert the bolts.
Note: Make sure that you insert the
bolts inside the embosser pointing
down through the mounting surface.
i.
Insert the bolts into the mounting
holes inside the embosser.
ii.
Align the bolts with the holes in the table or mounting surface.
iii.
Place a flat washer on each of the bolts, under the mounting surface.
c.
Secure the embosser using washers and nuts under the mounting surface.
Work
Surface
Lock Nut
Bolt
Washer