Data Translation MACH Series, User Manual

Page: 180 / 214

Appendix C
164
Windows 2000 Procedures
This section describes the following procedures in Windows 2000:
• Adding a board to the device driver configuration (on this page);
• Modifying the board settings in the device driver configuration
(on page 166 );
• Removing a board from the device driver configuration (on page
168 ); and
• Uninstalling the device driver, if necessary (on page 169 ).
Adding a Board to the Device Driver Configuration
To add a board to the DT3152-LS Device Driver configuration,
perform the following steps:
1. From the My Computer icon, double-click Control Panel .
2. Double-click Sounds and Multimedia .
3. Click Hardware .
4. Double-click DT-Open Layers DT3152-LS MACH Series Frame
Grabber .
5. Click Properties .
6. Double-click Multimedia Drivers .
7. Click Driver , then click Properties .
8. Click Settings .
9. Enter a name for the device, then click Add .
10. To configure the board for area-scan (two-dimensional)
operations, perform the following steps:
a. On the General tab of the DT3152LS Configuration dialog
box, click Enable 2 Dimensional Mode .