Data Translation MACH Series, User Manual

Page: 174 / 214

Appendix C
158
Windows NT 4.0 Procedures
This section describes the following procedures in Windows NT 4.0:
• Adding a board to the device driver configuration (on this page);
• Modifying the board settings in the device driver configuration
(on page 160 );
• Removing a board from the device driver configuration (on page
162 ); and
• Uninstalling the device driver, if necessary (on page 163 ).
Adding a Board to the Device Driver Configuration
To add a board to the DT3152-LS Device Driver configuration,
perform the following steps:
1. From the My Computer icon, double-click Control Panel .
2. Double-click Multimedia .
3. Click Devices .
4. Double-click Other Multimedia Devices .
5. Click DT-Open Layers DT3152-LS MACH Series Frame
Grabber .
6. Click Properties , click Use this device , then click Settings .
The DT3152-LS Configuration dialog box appears.
7. Click Add New .
The DT3152-LS Installation dialog box appears.
8. Enter a board name (alias), which can be any name you choose,
then click
Add . The board name is used by supported software,
such as DT-Acquire and the Frame Grabber SDK. Only one name
(alias) per installed board is allowed.
The DT3152-LS Configuration dialog box appears.