Data Translation MACH Series, User Manual

Page: 178 / 214

Appendix C
162
Removing a Board from the Device Driver
Configuration
To remove a board from the DT3152-LS Device Driver configuration,
perform the following steps:
1. From the My Computer icon, double-click the Control Panel .
2. Double-click the Multimedia icon .
3. Click Devices .
4. Double-click Other Multimedia Devices .
5. Click DT-Open Layers DT3152-LS Mach Series Frame Grabber .
6. Click Properties , click Use this Device , then click Settings .
The DT3152-LS Configuration dialog box appears.
7. Select the name of the board that you want to remove, then click
Remove .
8. Repeat step 7 until all the DT3152-LS boards you want to remove
are removed.
9. Click Close .
The Drivers dialog box appears. The DT3152-LS Device Driver is still
installed in the system, but the board has been removed.
10. If you want to uninstall the driver at this point, continue with
step 6 on
page 163 . Otherwise, continue with the next step.
11. Click OK , then click OK to finish.
12. Restart the system for the changes to take effect.