Preparing to Use a Function Module
9
2
2
2
2
2
2
2
2
2
Installing the Software
To install the software, perform the following steps:
1.
Insert the Data Acquisition OMNI CD into your CD-ROM drive.
2.
Click Start from the Task Bar, then click Run.
The Run dialog box appears.
3.
In the Command Line edit box, enter x:\LAUNCH.EXE (where x
is the letter of your CD-ROM).
4.
Click OK.
The Data Acquisition Software setup program starts.
5.
Click Install Products.
A list of software products that you can install appears.
6.
Click Device Drivers.
The DT-Open Layers Data Acquisition software wizard appears.
7.
Click Next.
You are prompted for the destination location.
8.
Either change the directory path and/or name using Browse or
accept the default directory, then click Next.
You are prompted to select the software components to install.
CAUTION:
This version of the Data Acquisition OMNI CD provides
WDM-compliant device drivers and DLLs (version 5.0 or greater).
Other Data Translation boards/modules may not provide
WDM-compliant drivers.
You cannot use a DT9820 Series module at the same time as another
Data Translation board/module unless both devices provide
WDM-compliant drivers.
Summary of Contents for DT9820 Series
Page 1: ...DT9820 Series UM 18219 B Getting Started Manual...
Page 20: ...Chapter 2 12...
