Data Translation DT340, Getting Started Manual

Page: 31 / 70

Installing a DT340 Board and Loading the Device Driver
23
3
3
3
3
3
3
3
3
3
Windows NT 4.0
In Windows NT 4.0, the driver is automatically loaded when you
install the DT340 driver from the Data Acquisition OMNI CD. To
configure the device driver, perform the following steps:
1. Open the Control Panel.
2. Double-click the Open Layers Control Panel icon.
3. Select the DT340 board to configure, then click Advanced.
4. Select the appropriate boxes to enable interrupts for lines (bits) 0
to 7 on digital port D, user counter/timers 0 to 7, and interval
timers 8 to 11.
5. When you are finished, click Close.
6. If you wish to change the name of the board, click Edit Name and
enter a new name for the board. Otherwise, exit from the Control
Panel.
Once the driver is loaded, perform the steps in Chapter 4 to attach
and configure the screw terminal panel for use with the DT340 board.
Windows 2000
Once you have installed the DT340 driver, installed a DT340 board,
and powered up the host computer, the New Hardware Found dialog
box appears. Perform the following steps to load the device driver in
Windows 2000:
1. Click Next.
2. Click Search for a suitable driver for my device (recommended).
3. Click Specify a location, and click Next.
4. Browse to WinNT/System32/Drivers/DT340.Inf, then click
Open
.
5. Click OK.