Data Translation DT3130 Series, User Manual

Page: 136 / 160

Appendix C
120
Windows 98 and Windows Me Procedures
This section describes the following procedures in Windows 98 and
Windows Me:
• Adding a board to the device driver configuration (on this page);
• Modifying the board settings in the device driver configuration
(on page 121 ); and
• Uninstalling the device driver, if necessary (on page 122 ).
Adding a Board to the Device Driver Configuration
To add a new board to the DT3130 Series Device Driver
configuration, perform the following steps:
1. Turn your computer off and insert the new DT3130 Series board
into your computer following the instructions in the
DT3130
Series Getting Starting Manual.
2. Turn your computer on and start Windows 98 or Windows Me.
The Add New Hardware Wizard dialog box appears.
3. Click Next .
4. For Windows 98:
Click
Search for the best driver for your device
(Recommended) , make sure all optional search locations are
unchecked, then click Next .
For Windows Me:
Click
Automatic search for a better driver (Recommended) .
5. Click Next .
The files are copied .
6. Click Finish .
7. Open the Control Panel.
8. Double-click the DT Imaging Control icon.