gForce Ultra IOM
116
Frequently Asked Questions (FAQ)
NOTE:
1. This Frequent Asked Questions Section applies only to the standard units
unless specified.
2. This Frequent Asked Questions Section does not apply to units with
special options or special design. This is based on factory settings.
3. Important. This is only for guideline and reference only. Subject to change
without notice. We reserve the right for product design improvements.
Information and data in this section maybe time sensitive.
4. Please refer to Maintenance section or other sections operating or setup
matters.
Electrical FAQ Section
Question 1:
What is FLA?
Answer:
Full load amp
Question 2:
What is MCA?
Answer:
Minimum circuit ampacity. This is used to help determine the wire size.
Question 3:
What is MOP?
Answer:
Maximum Overcurrent Protection device. This is to help determine the maximum protective
device.
Question 4:
What is the input voltage tolerance?
Answer:
In general it is +/- 10% but refer to Electrical Section for more details.
Question 5:
Will all units operate at 50 or 60 hertz power?
Answer:
No. This depends on the model and options selected. Consult with Data Aire for details.
Question 6:
Does the unit require an electrical ground?
Answer:
Yes. All units require a true earth ground.
Question 7:
What size field wire size is required to connect to unit?
Answer:
Refer to National Electric Code for wire ampacities size.
Question 8:
Does the condensate pump require separate power source?
Answer:
Floor unit with unit mounted condensate pump is powered by the unit.
Question 9:
Can I install an Emergency Power Off (EPO) switch, and if so, where is it installed?
Answer:
Yes, an Emergency power Off (EPO) switch can be installed. Refer to the electrical diagrams
and locate the terminal strip that is designated as the Remote Shutdown Contacts.
Summary of Contents for gForce Ultra
Page 1: ......
Page 123: ...gForceUltraIOM_11 2022 docx...
