DARLEY ZSP, Nstallation, Operation, Maintenance, Repair And Troubleshooting Instructions

Page: 85 / 155

16
Installation Techniques
Midship Mounted
Components
Mounting a Midship-Mounted PTO, Pump, or Auxiliary Transmission
When installing a midship-mounted PTO, auxiliary transmission, or midship-mounted pump into the main driveline of a vehicle,
install it at the same angle as the transmission. Keep the offset to a minimum to reduce universal joint operating angles.
Note: Do not make the universal joint operating angle less than 1/2 degree.
Before bolting the device in place, check the universal joint operating angles that occur at each end of the driveshaft. They must
be 1 to 1-1/2 degrees and they must be equal to within 1/2 degree for this type of application.
If the device ends up being installed in direct line with the transmission, with little or no universal joint operating angle on the
joints, raise or lower it so there is enough offset to create the required 1 to 1-1/2 degree universal joint operating angle on each
end of the driveshaft. (See Fig. 12)
If there is only one driveshaft between the device and the rear axle, rotate the rear axle (using shims in the appropriate place) so
it is the same angle as the device. This makes the universal joint operating angle at each end of the driveshaft equal (See Fig. 13).
Check the size of the universal joint operating angles to determine if they meet recommendations.
Figure 12
Figure 13
1/2
0
minimum
1
0
to 1-1/2
0
recommended
3
0
maximum
Equal within 1/2
0
Install at same angle
and in-line in top view
Auxiliary
Device
Install at same angle
and in-line in top view
Check size of
these angles
Rotate axle to same
angle as Auxiliary
Device
1/2
0
minimum
1
0
to 1-1/2
0
recommended
3
0
maximum
Equal within 1/2
0