PVE400M USER’S GUIDE
3. GETTING CONNECTED
PVE400M has a built-in web server. The whole configuration can be done using
Internet Browser
; no other
special software is required. All parameters on the configuration pages are stored in Non-Volatile RAM
(FLASH), so turning off the power will not reset them. New parameters will be stored by clicking the [
Apply
]
button with verification that all parameters are valid. The grayed values are read only, can’t be changed by user.
Web interface is very generic and works with any operating system and browser, excepting video plug-in, which
works only with
Microsoft Internet Explorer
version 6 or higher.
3.1 Accessing the device for the first time
The factory default configuration for Ethernet: IP 192.168.1.250 (static). To access PVE400M for the first time
using the wired connection, PC must be on the same network subnet.
The network settings can be changed using the
NETWORK
tab (see section 3.2). Changing IP address may
cause temporal disconnection. In this case reconnect to the device with a new IP address. The default
configuration for
MEA
card is
DHCP
client. Use
MeshManager
to properly setup and test connection.
Important Notes
:
MEA
card should be associated with
IAP
first, using the
MeshManager
software, before it will able
to get
IP
address from
DHCP
server. You will need to reboot the
PVE
device as soon as
IAP
association is completed.
Once connection is established and verified (by ping command), launch
Internet Browser
with URL of a current
IP address. For example:
http://192.168.1.250.
The standard authentication dialog will come out.
Figure 4. Authentication dialog
Copyright © 2007 Darim Vision Co, All Rights Reserved
- 11 -